Fuseboxes explained

Fuseboxes explained

Your Fuse board – the fuse board also known as consumer unit should be easy to find. You should make sure you know where it is in case you ever need to turn the electricity off in an emergency. It usually contains three things, and they are used to control and distribute electricity around your home. They are: The main switch; Fuses and/or circuit breakers; and Residual Current Devices.

One simple piece of advice, get an Emergency light installed by your Fuse-board, that way when the power trips out you can at least see what is going on, no trying to find a torch or light a match or lighter, and potentially burn the house down!

A) Main Switch – this allows you to turn off the electricity supply to your home. You might have more than one mains switch, for example if your home has electric storage heaters. In this case you may have a separate fuse board.

B) Residual Current Devices (RCD) these are switches that trip a circuit under dangerous conditions, and instantly disconnect the electricity.

If your home has one or more RCD, test them regularly. Just follow the instruction label, which you should find near to the RCD. It should read as follows:

“This installation, or part of it, is protected by a device which automatically switches off the supply if an earth fault develops. Test every three months by pressing the button marked ‘T’ or ‘Test’.”

Testing the button every three months is important. The device should switch off the electricity. You should then switch it back on to restore the electricity. Do not hold the test button for a long period if the RCD does not trip. If it doesn't switch off the electricity when you press the button, contact a registered electrician.

C) Circuit Breakers – these are automatic protection devices in the fuse-board that switch off a circuit if they detect a fault. They are similar in size to fuses, but give more precise protection. When they ‘trip’, you can simply reset the switch. But make sure you correct the fault first.

Fuses (not on the image, may be found in place of circuit breakers) –rewirable fuses have a piece of special fuse wire running between two screws. When a fault or overload current flows through the fuse wire, it will become hot and melt. The melted fuse breaks the circuit, disconnecting the faulty circuit and keeping you safe.

If your fuse-board has a wooden back, cast iron switches, or a mixture of fuses it is likely that it dates back to before the 1960s and will need to be replaced.

For further information, Contact us today  on 0800-542-0638

On our website: - www.safe-electric.com